Fixed Glass Assembly; Install The Mesh; Install Trim And/Or Surround; Install Hood - Heat & Glo Everest Owner's Manual

H. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
• Pull the four glass assembly latches out of the groove on
the glass frame. Remove glass door from the appliance
(see Figure 14.2).
Replacing Fixed Glass Assembly
• Replace the glass door on the appliance. Pull out and
latch the four glass assembly latches into the groove on
the glass frame.
LATCHES
GLASS
ASSEMBLY
Figure 14.2 Fixed Glass Assembly
I. Install the Mesh
• Attach mesh frame to glass frame using four metal mesh
clips included with appliance.
J. Install Trim and/or Surround
• Install optional trim kits and/or surrounds using the
instructions included with the accessory.
• Use non-combustible materials to cover the gap between
the sheet rock and the appliance (when applicable to the
model).
48
K. Install Hood
L. Air Shutter Setting
Air shutter settings should be adjusted by a qualifi ed ser-
vice technician at the time of installation. The air shutter
is set at the factory for minimum vertical vent run. Adjust
air shutter for longer vertical runs.
Air Shutter Settings
Heat & Glo • Everest • 750-900 Rev. T • 5/12
NG
MAIN 1/8 IN.
LOGS 1/8 IN.
LP
Full Open
Full Open