Connecting The Speakers; Connecting External Equipment - JVC UX-V55R Instructions Manual

CAUTION: Make all connections before plugging the System into an AC power outlet.

Connecting the Speakers

For each speaker, connect one end of the speaker wire to the speaker terminals on the back of the System.
1. Open each of the terminals and insert the speaker wires firmly, then close the terminals.
2. Connect the red (+) and black (–) wires of the right side speaker to the red (+) and black (–) terminals marked R on the System.
Connect the red (+) and black (–) wires of the left side speaker to the red (+) and black (–) terminals marked L on the System.
CAUTION: A TV may display irregular colors if located near the speakers. If this happens, set the speak-
ers away from the TV.

Connecting External Equipment

Connect signal cords (not supplied) between the System's LINE IN (AUX)/LINE OUT terminals and the output/input terminals of the external
MD recorder, tape deck, etc.
You can then listen to the external source through the System, or record the System's CD player, cassette tape, or tuner to the external unit.
R
Connecting an MD Recorder, etc (Digital Output)
Unplug the cap and connect an optical digital cord (not supplied) between the System's OPTICAL DIGITAL OUT terminal and the input ter-
minal of the MD recorder, etc.
You can record the digital output signal from the System's CD Player to the MD recorder, etc.
OPTICAL
DIGITAL OUT
4
Right speaker (rear side)
Black
Signal cord (not supplied)
Pin-plug x 2
LINE OUT
L
LINE IN
Signal cord (not supplied)
(AUX)
Pin-plug x 2
Cap
Optical digital cord (not supplied)
Left speaker (rear side)
L
R
SPEAKERS
IMPEDANCE
MIN 4
MD recorder or tape deck (not supplied)
Pin-plug x 2
Pin-plug x 2
MD recorder, etc. (not supplied)