Adding Salt - Kenwood KDW60S12 Installation Instructions Manual

adding salt

If the water in your area is hard, deposits will form on your dishes and utensils. This appliance
contains a salt reservoir for you to reduce the hardness of the water.
Please follow the steps below to pour the salt into the salt reservoir. It must be set to correspond to
the water hardness level in your area.
1. Remove the lower basket and unscrew the reservoir cap.
2. Fill the reservoir with approximately 500ml of water (first use
only).
3. Place the funnel provided over the salt reservoir.
4. Pour in approximately 1.2kg of dishwasher salt depending on the
brand used.
5. Clean any excess salt from around the reservoir opening and
then screw the cap on again firmly.
6. Run the "rapid" wash programme immediately (without any
crockery in the dishwasher) to remove any traces of salt from the
compartment.
• The salt warning light will illuminate when the reservoir is
running out of salt and requires re-filling.
• After filling, the salt warning light will cease to illuminate within a
few days depending on how quickly the salt dissolves.
If you decide to use a detergent tablet, you do not need
to add rinse aid to the rinse aid reservoir.
* All images are for reference only; please refer to your individual unit for actual item.
16
KDW60S12_IB_120416_Running Change_Annie.indd 16
open
open
salt
warning
light
open
12年4月16日 下午7:01