Installation Notes - Sharp MX-M623N Start Manual

Back

Installation notes

Do not install the machine on an unstable or
slanted surface. Install the machine on a surface
that can withstand the weight of the machine.
Risk of injury due to the machine falling or toppling.
If peripheral devices are to be installed, do not
install on an uneven floor, slanted surface, or
otherwise unstable surface. Danger of slippage,
falling, and toppling. Install the product on a flat,
stable surface that can withstand the weight of the
product. (Weight when various peripheral devices
are installed: approx. 718 lbs. (326 kg))
Do not install in a location with moisture or
dust.
Locations that are excessively hot, cold, humid,
or dry (near heaters, humidifiers, air
conditioners, etc.)
The paper will become damp and condensation
may form inside the machine, causing misfeeds and
dirty output.
☞
Ambient environment (page 45)
If the location has an ultrasonic humidifier, use pure
water for humidifiers in the humidifier. If tap water is
used, minerals and other impurities will be emitted,
causing impurities to collect on the inside of the
machine and create dirty output.
CAUTION
Risk of fire and electrical shock.
If dust enters the machine, dirty
output and machine failure may
result.
When the machine is installed, the adjusters (4)
must be lowered to the floor to secure the
machine (prevent it from moving).
Rotate the adjusters in the locking direction until
they are in firm contact with the floor.
If you find it necessary to reposition the
machine due to rearrangement of your office
layout or other reason, retract the adjusters
from the floor, turn off
the power, and then
move the machine.
(After moving the
Adjuster
machine, lower the
adjusters again to secure
the machine.)
Lock
Release
Locations exposed to direct
sunlight
Plastic parts may
become deformed
and dirty output may
result.
Locations with ammonia gas
Installing the machine next to a
diazo copy machine may cause
dirty output.
CAUTIONS
3