Display Colours: Status Led - Revox Joy S119 User Manual

Presentation

Display colours: Status LED

Dark-blue

Quickstart function [off]:
In this standby mode, all functions,
with the exception of the radio
module, are deactivated.
Power consumption: < 0.6 W*
Light-blue

Quickstart function [on]:
Unit is in standby mode. If the
Quickstart function is activated, the
network processor is switched on
permanently. This significantly reduces
the switch-on
connection to the network doesn't
have to be built up again. All other
sub-assemblies, such as the audio
signal processing or the outputs,
including the main transformer are
switched off, as with normal standby
mode. Quickstart mode is also a
requirement, in order to be able to
control the receiver with a network-
based Revox App.
Power consumption: approx. 4.5 W*
The USB input supports the charging of
external devices, e.g. an iPhone in
standby mode.
* without USB feed
.
9
phase, as the
Green (flashing)

After switching on at the power switch,
the status LED flashes green for about 10
seconds. During this time, the S208 remote
control can be paired/ synchronised with
the receiver, i.e. these two devices can be
connected with each other, functionally.
You will find the necessary steps for this
procedure explained in the
control
chapter.
Red (flashing)

A non-defined fault has occurred. If
necessary, switch the unit off and on
using the power switch.
Red (permanent)

The timer in the network receiver is
active. This can be the case, for example,
if the timer function is activated, with
which the receiver switches itself on
automatically after a certain time.
White 
The receiver is in operation.
network receiver
S208 Remote