Table of Contents
Advertisement
network receiver
Speaker Setup
Through the Speaker menu, you can
make all the basic settings to adjust your
Revox speakers to optimally match your
installation
environment
S119/S120.
For the development of the DSP system,
Revox
measured
Re:sound
speakers
characteristics under studio conditions
and added this information to the
amplifier characteristic curve. As well as
the
audio-physical
performance range of the speaker is
taken into account and if necessary, the
maximum output performance of the
speaker outputs is throttled back. This
guarantees that your speaker is only
subjected to the power that it can handle
both mechanically and thermally, even
when the unit is at full load.
DSP: Digital Signal Processor
and
the
all
the
current
and
their
parameters,
the
Three steps to perfection:
1. Selecting the speakers
Using the buttons, select the Revox
speaker type you want to operate with
your S119/S120. You can scan through
the current Revox models in an endless
loop. Needless to say, future models will
be made available for selection through
a software update. As soon as a Revox
speaker is selected, this is indicated
when the
DSP
changes colour to
If your speaker is not in the list, use the
selection: Any/ Unknown. A linear
amplifier characteristic curve is used
with this setting.
2. Choosing the location
The
location
significantly influences the playback
quality, particular in the bass range. The
speaker setup offers three location
options:
[Neutral]
Your
speakers
studio conditions
[Near wall]
Your speakers are standing less than
0.5 metres away from a wall. The
slightly increased bass reproduction
that this causes is compensated for, so
that a neutral playback is achieved, in
spite of the proximity to the wall.
Configuration
text on the display
.
DSP
of
your
speakers
are
free-standing:
28
Advertisement
Table of Contents
