Troubleshooting - JVC UX-G30UW Instructions Manual

Advanced Disc Operations
Programming the Playing Order—Program Play:
• You cannot specify a group number of an MP3 disc for
Program Play.
• If you try to program the 100th track, "FULL" appears on
the display.
Recording Operations
Recording on a Tape:
• The recording level is automatically set correctly. Thus,
you can adjust the sound without affecting the recording
level.
• There is leader tape which cannot be recorded onto at the
start and end of cassette tapes. Thus, when recording from
CD or radio broadcast, wind the leader tape first to ensure
that the recording will be made without any music part lost.
• If you try to start recording with no cassette inserted or with
a protected tape, your request will be ignored and
"NO REC" appears on the display.
Synchronized Disc Recording:
• When the tape reaches its end while recording, recording
stops even though the disc is not entirely recorded.
• You cannot open the disc tray while recording from CD.
– If you press 0 button while recording from CD, "REC"
appears on the display.
• You cannot activate Repeat Play while recording.
To protect your recording
Cassettes have two small tabs on the back to protect
from unexpected erasure or re-recording.
To protect your recording, remove these tabs.
To re-record on a protected tape, cover the holes with
adhesive tape.
(see pages 13 and 14)
(see page 15)
Timer Operations
(see pages 16 and 17)
• When you unplug the AC power cord or if a power failure
occurs, the timer will be canceled. You need to set the
clock first, then the timer again.
• Without stopping the recording, you cannot change the
source after Recording Timer starts recording.
• If you set Sleep Timer after Recording Timer starts
recording, recording continues until Sleep Timer turns off
the power.

Troubleshooting

If you are having a problem with your System, check this list
for a possible solution before calling for service.
General:
Adjustments or settings are suddenly canceled before
you finish.
] There is a time limit. Repeat the procedure again.
Operations are disabled.
] The built-in microprocessor may malfunction due to
external electrical interference. Unplug the AC power
cord and then plug it back in.
Unable to operate the System from the remote control.
] The path between the remote control and the remote
sensor on the System is blocked.
] The batteries are exhausted.
No sound is heard.
] Speaker connections are incorrect or loose.
] Headphones are connected.
Radio Operations:
Hard to hear broadcasts because of noise.
] Antennas connections are incorrect or loose.
] The AM loop antenna is too close to the System.
] The FM antenna is not properly extended and positioned.
19