Activate Surround Or Dsp Mode; Stop Playback - JVC TH-A35 Instructions Manual

To turn off the sounds temporarily
From the remote control ONLY:
Press MUTING.
To restore the sound, press MUTING again.
• Pressing AUDIO VOL + or – also restores the sound.
6

Activate Surround or DSP Mode

You can enjoy Dolby Pro Logic II mode and DSP modes.
Dolby Pro Logic II—Pro Logic II Movie and Pro
Logic II Music
To activate Pro Logic II modes
Press SURROUND.
The current Pro Logic II mode appears on the display
for a while.
• Each time you press the button, Pro Logic II mode
changes as follows:
PL II MUSIC
PL II OFF
• When Dolby Pro Logic II mode is activated, the
II indicator lights up on the display.
– For in-depth information about Dolby Pro Logic II modes, see
"Creating Realistic Sound Fields" on pages 19 to 21.
DSP modes—CONCERT, STADIUM, HALL,
THEATER, LIVE HOUSE
To activate DSP modes
Press DSP.
The current DSP mode appears on the display for a
while.
• Each time you press the button, DSP mode changes
as follows:
LIVE HOUSE
DSP OFF THEATER
– For in-depth information about DSP modes, see "Creating
Realistic Sound Fields" on pages 19 to 21.
Note:
Before activating the Surround or DSP mode, adjust the speaker
setting to bring out the best performance from this system.
For in-depth information about adjusting the speaker setting, see
"Setting Menu" on pages 55 and 56.
MUTING
SURROUND
PL II MOVIE
PRO LOGIC
DSP
HALL CONCERT
STADIUM
7

Stop Playback

Press 7 twice.
Playback stops completely.
• This system can memorize the end point even when
you press 7 once. When you start playback again by
pressing 3, playback begins from where it has been
stopped—Resume play.
To remove the loaded disc
Press 0.
"OPEN" appears on the display and the disc tray comes
out.
To close the disc tray, press 0 again.
To prohibit disc ejection
On the front panel ONLY:
Press and hold 6 and 4 for more than
3 seconds.
"LOCKED" appears on the display, and the
disc tray is locked.
To cancel the prohibition, press and hold
6 and 4 for more than 3 seconds.
"UNLOCK" appears on the display, and the
disc tray is unlocked.
To turn off the power (into standby)
Press AUDIO (or
STANDBY/ON on the front panel).
The illumination lamp goes off and the STANDBY lamp
lights up.
• If you press AUDIO (or
panel) while the disc tray is kept open, the disc tray closes
automatically, then the system is turned off.
• A small amount of power is consumed even in standby mode. To
turn the power off completely, unplug the AC power cord.
AUDIO
STANDBY/ON on the front
13