Car Adapter Mode; Wheel Light Timeout; Keyclick; Usb Hid - SanDisk Sansa e200 Series Manual Manual

Chapter 8. General Settings

8.5.4. Car Adapter Mode

This option turns On and Off the car ignition auto stop function.
Car Adapter Mode. When using the player in a car, Car Adapter Mode automat-
ically stops playback on the player when power (i.e. from cigarette lighter power
adapter) to the external DC in jack is turned off. If the Car Adapter Mode is
set to On, Rockbox will pause playback when the external power off condition is
detected. Rockbox will then shutdown the player after the length of time set in
the Idle Poweroff setting (see section
jack is turned back on before the Idle Poweroff function has shut the player off,
playback will be resumed 5 seconds after the power is applied. This delay is to
allow for the time while the car engine is being started.
Once the player is shut off either manually, or automatically with the Idle Poweroff
function, it must be powered up manually to resume playback.

8.5.5. Wheel Light Timeout

This setting controls the amount of time the wheel lights shine after a button press or
wheel turn. If set to Off, the LEDs will not light when a button is pressed. If set to
On, the lights will never shut off. If set to a time (1 to 120 seconds), the wheel will stay
lit for that amount of time after a button press or wheel turn.

8.5.6. Keyclick

This menu controls key clicks on button presses.
Keyclick. This setting controls how strong the keyclicks are. If set to Off, the keyclicks
will be disabled.
Keyclick repeats. This setting turns keyclick repeats On and Off. If set to On, the
keyclicks will be repeated when you hold down a button. If set to Off, you will
hear only one click.

8.5.7. USB HID

This option turns the USB HID feature On and Off. When this feature is enabled, the
player enumerates as a Human Interface Device (HID), composed of several HID sub
devices. Since the player also enumerates as a Mass Storage Device, it becomes a USB
Composite Device, which contains both these devices.

8.5.8. USB Keypad Mode

This setting control the keypad mode when the player is attached to a computer through
USB. Pressing a key on the player sends a keystroke the computer the player is attached
to, according to the mapping set by the keypad mode. There are different modes which
The Rockbox manual
(version rUnversioned directory-150220)
8.6.2 (page 75)). If power to the DC in
Sansa e200 and e200R Series
72