Britax Baby Safety Capsule Instructions For Installation & Use page 12

HOW TO INSTALL
C. Grasp the seat belt tongue from inside the Base, pull
through the Base and pass up through the slot on the
other side. The seat belt may be over or under the
plastic strip at the centre inside the Base.
D. Grasp the seat belt tongue and pull right through the
seat belt path.
E. Engage the seat belt tongue to the buckle.
Tighten the seat belt to hold the Base firmly
against the seat back.
22
- Series number: 2030/A/2010
Instructions for Installation & Use
Pull sash portion
of seat belt to
remove slack.
Engage seatbelt
INSTALLING UPPER ANCHORAGE STRAP
A. Locate the child restraint anchor fitting in the
car that is directly behind the seat location in
the rear seat you have chosen. Refer to the
car owner's manual for the location (If there
is no anchorage fitting then refer to page 38
for instructions in adding an anchor fitting.)
C
Connect the Upper Anchorage Strap Attachment
Clip to the Anchor Fitting.
Lengthen the strap by pressing the adjuster
button (1) and pull the strap (2) so that the
strap is ready to attach to the Carrier.
THIS UPPER ANCHORAGE STRAP MUST
ALWAYS BE FITTED WHEN THE INFANT
CARRIER IS USED IN THE CAR.
D
Always attach hook and remove slack.
B. While the Infant Carrier is out of the car, store the upper anchorage strap between the
stabilising bar and the car seat back so that it will be ready for use when the Infant Carrier
is put back in the car.
C. If the seat belt will not stay tight, then fit the 3-bar gated buckle to the lap-sash belt to
prevent loosening. See pages 43 to 44. Rarely are these needed.
E
HOW TO INSTALL
Fully press Adjuster Button (1)
while pulling Upper Anchorage
Strap (2) to lengthen.
- Series number: 2030/A/2010
Instructions for Installation & Use
Attachment Clip
Car's Anchor Fitting
1
2
3
23