Replacing Filler Panels And Backplates - ADC Cuda 12000 Installation Manual

Replacing Filler Panels and Backplates

Cuda 12000 IP Access Switch Installation Guide
Table 4-1 identifies the module types supported by each chassis slot.
Table 4-1 Module Location Based on Slot
Slot
1
2– 11
12
13, 14
CAUTION: Appropriate backplates must be in place prior to installing
modules.
This section provides the replacement procedures for these items:
Filler Panels: Blank aluminum faceplates that occupy unused chassis
slots to ensure proper air flow over vital components.
Backplates: Aluminum plates that cover the back of each chassis slot
and enable CableOnce (blind-mate) connectivity to network modules.
Ensure that all unused chassis slots contain a filler panel and are covered by a
backplate. Backplates keep dust and debris out of the chassis slot, helps
maintain the cooling integrity of the system, and is required to meet FCC
compliance.
Replacing Filler Panels and Backplates
Modules Accepted
DOCSIS
EuroDOCSIS
10/100 Ethernet
Cuda Protocol Analyzer
DOCSIS
EuroDOCSIS
10/100 Ethernet
POS
Gigabit Ethernet
Cuda Protocol Analyzer
DOCSIS
EuroDOCSIS
Gigabit Ethernet
POS
Cuda Protocol Analyzer
Management Modules
79