Packet Over Sonet (Pos) Spectraflow Modules - ADC Cuda 12000 Installation Manual

46 C 1: H
HAPTER ARDWARE
Fiber Type
Multi mode
Single mode 9
Single mode 9
O
VERVIEW

Packet Over SONET (POS) SpectraFlow Modules

The system supports transmission of IP data directly over Synchronous
Optical Network (SONET) to more efficiently utilize bandwidth and leverage
the management, fault-tolerance, and high transmission speeds inherent in
SONET networks.
The system supports connection to SONET networks using these modules:
POS Module Description
POS OC-3 Provides a 155 Mbps connection to SONET STS-3c or SDH
STM-1 networks.
POS OC-12 Provides a 622 Mbps connection to SONET STS-12c or
SDH STM-4 networks.
POS modules connect to the network using the provided fiber-optic cable.
This fiber optic cable consists of a duplex SC connector on one end and an
AMP MPX connector on the other end. The module is connected to the
network by installing a fiber module backplate on the selected slot, then
inserting the AMP MPX connector into the blind-mate fiber port located on
the backplate. Cabling to the backplate and not to the module itself allows
you to remove and replace the module without re-cabling. It also allows you
to cable slots in advance.
Both OC-3 and OC-12 POS modules are available in a number of
configurations. Table 1-6 shows the available configurations and associated
parameters of OC-3 modules.
Table 1-6 POS OC-3 Configurations
Diameter Wavelength
(microns) (nanometers)
62.5 1300
1300
1300
Transmission Optical
Distance Output Power
2 kilometers Min: -20 dBm
Max: -14 dBm
15 kilometers Min: -15 dBm
Max: -8 dBm
40 kilometers Min: -5 dBm
Max: 0 dBm
Input
Sensitivity
Min: -31 dBm
Max: -14 dBm
Min: -31 dBm
Max: -8 dBm
Min: -34 dBm
Max: -8 dBm
ADC Telecommunications, Inc.