1X4 Docsis Spectraflow Module - ADC Cuda 12000 Installation Manual

Application Modules 31

1x4 DOCSIS SpectraFlow Module

The 1x4 DOCSIS SpectraFlow module offers four upstream RF ports and a
single downstream RF port. The four upstream ports each provide up to a 10
Mbps connection to hybrid fiber coaxial (HFC) cable and support both QPSK
and 16 QAM modulation schemes within a frequency range of 5 to 42 MHz.
The single downstream port provides up to a 40 Mbps connection to your
HFC network and supports both 64 and 256 QAM modulation schemes
within a 93 MHz to 855 MHz frequency range. The downstream port is
compliant with ITU J83 Annex B FEC for 6 MHz channelization.
The module is connected to the network by installing a DOCSIS module
backplate on the selected slot, then cabled to the RF connectors attached to
the backplate. Cabling to the backplate and not to the module itself allows
you to remove and replace the module without re-cabling; it also allows you
to cable slots in advance. For information about installing a DOCSIS module
backplate, see "Backplates"on page 83.
These modules are SpectraFlow enabled. For information about SpectraFlow,
see "Application Module Features"on page 26.
These modules are hot-swappable; this means you can remove and replace
the modules with the system powered on and running.
Figure 1-6 shows a 1x4 DOCSIS SpectraFlow module. For a description of
each numbered callout, see Table 1-2 on page 26.
Cuda 12000 IP Access Switch Installation Guide