Oscillator Section - Tone2 Rayblaster Reference Manual

High Boost:
Boosts high formant frequencies, this boost can provide some additional punch to sounds
when a decaying envelope is routed to Formant.
Example Patches in Patch manager >Tutorial category: FakeFilterSquare
Oscillator section parameters (knobs and buttons)
Inside the Main oscillator section you'll find the following controls:
Formant:
This is the most important parameter of Rayblaster. Formant controls the formant
frequency, the cutoff of the filter impulse responses, the pitch of granular sounds or
in general the brightness of your sound.
When Formant key follow is set to a value of 100, Formant values lower than 0 will
result in a low-pass-style characteristic, Formant values higher than 0 will result in a
bandpass-style characteristic.
Example Patches in Patch manager >Tutorial category: FakeAnalogFilter, MonoBass,
FormantSynthesis.
Damp:
Damp is also a very important parameter, it is used to dampen/darken the sound. You
use the damp control if an oscillator sounds too sharp or aggressive in tone.
Example Patches in Patch manager >Tutorial category: Damped Square