Lfos - Tone2 Rayblaster Reference Manual

4.4 LFOs

There are two LFO's available within Rayblaster. Both are freely assignable from within the
modulation matrix and can be used for basically anything from modulating the Formant to
modulating an oscillator's harmonics or pulse-width.
LFO WAVEFORM BUTTON – This cycles the waveform for the LFO to be used. The
available waveforms are :
I) Sine
II) Triangle
III) Square
IV) Saw
V) Sample & Hold
VI) Ramped Noise
Note: Additional LFO waveforms (Like a sinoid or smoothed versions) can be created by using
the filter (X) function in the matrix.
FREQ. - This controls at which frequency the LFO runs; the LFO speed
BPM – This will synchronize the LFO's frequency to the host.
PHASE – This will adjust the starting position of the LFO's waveform, when the knob is
turned completely to the left it the LFO will be free running.