The Modulation Matrix - Tone2 Rayblaster Reference Manual

Table of Contents

Advertisement

4.5 Modulation Matrix
The MOD MATRIX or Modulation Matrix is a system that allows you to flexibly assign
different modulators (such as LFOs or envelopes) to different destinations (such as the
filter, amplifier or even other modulators).
There are three modulation matrix pages available, each page offering 5 different
assignable modulation slots.
To use the mod matrix the procedure is very simple:
1. Choose a modulator (modulation source) in the drop-down menu. This is what
causes the modulation or changing effect
2. Choose a target (destination) in the drop-down menu. This is what gets affected
by the modulation or changing effect.
3. Drag the slider in the center of the bar left or right in a negative (left) or positive
(right) direction to increase or decrease the values.
Source menu options:
Off : Default matrix source is set to off
Vol Env : The Volume envelope will be used as
modulation source
Env1 : The Auxilary 1 envelope will be used as
modulation source
Env2 : The Auxilary 2 envelope will be used as
modulation source
LFO1+- : LFO1 in bipolar mode as modulation source,
this uses LFO1's negative and positive values
LFO2+- : LFO2 in bipolar mode as modulation source,
this uses LFO1's negative and positive values
LFO1+ : LFO1 in unipolar mode as modulation source,
only uses LFO1's positive values

Advertisement

Table of Contents
loading

Table of Contents