Setting Up For The First Time - ProScan PLT8031 User Manual

will turn on till the turning-on picture is over.
-- Power off: Press it for 5 seconds. The system would indicate
some options : Muting or Power off. Click "Power off" to shut it down.
【TIPS 】:
1.When the battery is low, it will power off automatically.
2.Shutdown illegally, when you restart, device would scan and repair the disk. The screen will stay at the progress bar for a long time.
3.Definition of "Press":
Short Press: Press the button less than 2 seconds.
Long Press: Press the button more than 3 seconds.

Setting up for the first time

Charging your device:
For first-time use, you need to charge the device for ten hours.
After that you can recharge the device as needed.
Connect the DC-in jack to your device and plug the AC adapter into any AC outlet.
【TIPS】:
1. This device adopts built-in polymer battery. Only the specified charger should be used.
2. It is normal for the device's surface to become warm during charging or long
time of use. All devices are factory tested before release.
3. If you do not use this set for a long time, please charge/release it once
a month to avoid deep discharge. The damage caused by battery over-consuming is not
included in the warranty.
If there is no special explain, "Press" means Short Press.
4
User Manual