(S); Dmc-Lz4 (S) - Panasonic Lumix DMC-LZ4PP Service Manual

Service Manual
Diagrams and Replacement
Parts List
Digital Camera
DMC-LZ3 SERIES
DMC-LZ4 SERIES
DMC-LZ5 SERIES
Vol. 1
Colour
(S)...........Silver Type
Table of contents
S1. About Indication of The Schematic Diagram ............................ S-1
S1.1. Important Safety Notice......................................................... S-1
S2. Voltage Chart ........................................................................... S-2
S2.1. Flash Top P.C.B. .................................................................... S-2
S3. Block Diagram .......................................................................... S-3
S3.1. Overall Block Diagram .......................................................... S-3
S3.2. System Control Block Diagram ............................................. S-4
S3.3. Video/Audio Process Block Diagram .................................... S-5
S3.4. Sensor Block Diagram .......................................................... S-6
S3.5. Lens Drive Block Diagram..................................................... S-7
S3.6. Power Block Diagram............................................................ S-8
S4. Schematic Diagram .................................................................. S-9
S4.1. Interconnection Diagram ....................................................... S-9
S4.2. AF Assist Schematic Diagram ............................................. S-10
S4.3. Flash Top Schematic Diagram ............................................ S-11
S4.4. Lens Flex Schematic Diagram ............................................ S-12
S4.5. CCD Flex Schematic Diagram ............................................ S-13
DSC0602003CE / DSC0602005CE
S1. About Indication of The Schematic Diagram
S1.1. Important Safety Notice
COMPONENTS IDENTIFIED WITH THE MARK
FOR SAFETY. WHEN REPLACING ANY OF THESE COMPONENTS USE ONLY THE SAME TYPE.
1.Although reference number of the parts is indicated on the P.C.B. drawing and/or
schematic diagrams, it is NOT mounted on the P.C.B. when it is displayed with "$" mark.
2.It is only the "Test Round" and no terminal (Pin) is available on the P.C.B.
when the TP (Test Point) indicated as "
3.The voltage being indicated on the schematic diagram is measured in
"Standard-Playback" mode when there is no specify mode is mentioned.
4.Although the voltage and waveform available on here is measured with standard frame,
it may be differ from actual measurement due to modification of circuit and so on.
5.The voltage being indicated here may be include observational-error (deviation) due to
internal-resistance and/or reactance of equipment. Therefore, handle the value
indicated on here as reference.
6.Use the parts number indicated on the Replacement Parts List .
7.Indication on Schematic diagrams:
S5. Print Circuit Board .................................................................. S-14
S5.1. AF Assist P.C.B. .................................................................. S-14
S5.2. Flash Top P.C.B. . ................................................................ S-14
S5.3. Lens Flex P.C.B. ................................................................. S-15
S5.4. CCD Flex P.C.B. ................................................................. S-16
S6. Replacement Parts List .......................................................... S-17
S7. Exploded View ....................................................................... S-23
S7.1. Frame and Casing Section (1) ............................................ S-23
S7.2. Frame and Casing Section (2) ............................................ S-24
S7.3. Packing Parts and Accessories Section .............................. S-25
S-1
" mark.
Circuit name being connected.
This signal is connected
OFTR FEP
to the FEP schematic diagram
Name of Signal
HAVE THE SPECIAL CHARACTERISTICS