Power Cord/Pressure Switch; Inlet Valve/D.t Housing/Lid Assembly; Top/Tub Cover/Pulsator/Inner Tub - LG WT4801CW Service Manual

Pipe
Pipe
Inner Tub Cap
Inlet Valve
ASM
Connector
Hose
Pressure
Tub Cover
2) Disassembly of Power Cord, Inlet
Valve ASSEMBLY, D.T Housing
ASSEMBLY and Pressure Switch.
Disassemble back panel.
Disconnect three connectors and disassemble the
power cord.
Remove two pipe fixing screws and three inlet valve
screws.
Disconnect the leads from the inlet valve.
Separate the pipe and the connector hose from the
inlet valve.
Remove the inlet valve.
Disconnect the leads and pressure tube from the
BP sensor.
3) Disassembly of Lid Assembly, Top
Cover, Tub Cover, Pulsator, and Inner
Tub
Remove three lid fixing screws.
Disassemble the lid assembly in arrow direction.
Remove two top cover attaching screws in the rear
then disassemble the top cover.
Remove the tub cover attaching screws then
disassemble tub cover.
Remove the pulsator attaching screws then
disassemble the pulsator.
Remove the hub fixing nut by a special tool.
Disassemble the inner tub.
Shaft
Rotor Nut
Hub fixing nut
20
Inner Tub Cap
Hub Fixing Nut
Out Tub
Inner Tub
Bearing Housing ASM
Rotor
Stator