Common Operations; Turning On Or Off The Power; Setting The Clock; Selecting The Sources - JVC MX-GB5C Instructions Manual

Common Operations

Turning On or Off the Power

To turn on the unit, press
so that the standby lamp goes off.
To turn off the unit (on standby), press
STANDBY/ON again so that the
standby lamp lights up.
A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to "– – : – –" soon, while the tuner preset stations
(see page 12) will be erased in a few days.

Setting the Clock

Before operating the unit any further, first set the clock built
in this unit. You can set the clock whether the unit is on or
off.
On the unit ONLY:
1
Press CLOCK/TIMER.
The hour digits start flashing on the display.
2
Press ¢ or 4 to adjust
the hour, then press SET/
DISPLAY.
The minute digits start flashing on the display.
• If you want to correct the hour after pressing SET/
DISPLAY, press CANCEL/DEMO. The hour
digits start flashing again.
9
STANDBY/ON
3
Press ¢ or 4 to adjust
the minute, then press
SET/DISPLAY.
To check the clock time
Press and hold SET/DISPLAY for more than
2 seconds while playing any source.
• To return to the source indication, press
SET/DISPLAY.
While the time indication appears on the display
If you press a button or turn a control, the time indication returns to
the source indication.
To adjust the clock again
If you have adjusted the clock before, you need to press
CLOCK/TIMER repeatedly until "CLOCK" is selected.
• Each time you press the button, the clock/timer setting
modes change as follows:
DAILY ON TIME
(Daily Timer)
Canceled CLOCK
If there is a power failure
The clock loses the setting and is reset to "– – : – –." You need to set
the clock again.

Selecting the Sources

To listen to the radio, press FM/AM. (See page 12.)
To play back CDs, press CD 6. (See pages 13 – 19.)
To play back tapes, press TAPE A 3 or TAPE B 3. (See
page 20.)
To select the external equipment as the source, press AUX.
When you press the play button for a particular source (AUX,
FM/AM, CD 6, TAPE A 3, and TAPE B 3), the unit turns
on (and the unit starts playing the source if it is ready—
COMPU PLAY CONTROL).
REC
ON TIME
(Recording Timer)