Advertisement
Switch action (Fig. 12)
CAUTION :
Before plugging in the tool, always check to see that the switch trigger actuates properly
and returns to the "OFF" position when released.
To start the tool, simply pull the trigger.
Release the trigger to stop. For continuous
operation, pull the trigger and then push in
the lock button. To stop the tool from the
locked position, pull the trigger fully, then
release
it.
Switch t r i g g e k L o c y u t t o n
Fig. 12
Continuous running (Fig. 12)
Press the trigger and
a t
the same time push the lock button. To stop this lock position,
press the trigger and release it.
Variable trigger speed control (Fig. 12)
The speed varies from 0 to maximum, depending on the pressure applied to the trigger.
The more the trigger
i s
pressed, the faster the tool runs.
Reversing switch action (Fig. 13)
This tool has
a
reversing switch to change
the direction of rotation. Press the upper
side (FWD side) of the switch for clockwise
rotation or the lower side ( R E V side) of
the switch for counterclockwise rotation.
Reversing switch
Fig. 1:
CAUTION :
0
Always check the direction of rotation before operation.
.Use the reversing switch only after the tool comes to
a
complete stop. Changing the
direction of rotation before the tool stops may damage the tool.
9
Advertisement
