Makita 6832 Instruction Manual page 6

Adjust the stopper plate in accordance with the screw length as shown in Fig, 3 81 4. If
necessary, loosen the bolts which secure the stopper plate.
Fig. 3-1 : For screws 25 mm (1")
-
28 mm (1-1/8") long
Fig. 3-2: For screws 28 mm (1-1/8")
-
35 mm (1-3/8") long
Fig.3-3: For screws35 mm (1-3/8") - 4 1 mm (1-5/8") long
Fig. 4-1 : For screws 40 mm (1-9/16")
-
44 mm (1-3/4") long
Fig. 4-2 : For screws 44 mm (1-3/4")
-
51 mm (2") long
Fig. 4-3: For screws 51 mm (2")
-
57 mm (2-1/4") long
Then tighten the bolts to secure the stopper plate.
NOTE :
As for Fig. 3-2, 3-3, 4-2 & 4-3, secure the stopper plate with both ends contacting the
pins on each side to keep the stopper plate from tilting.
Pin
Fig.
3-
1
Fig.
3-2 Fig.
3-3
Fig.
6