Craftsman 247.889704 Operator's Manual page 23

4. Carefully pivot the snow thrower upand forward so that i trests o n
the auger housing.
5. Remove the frame c over from the underside ofthe snow thrower
byremoving the self-tapping screws which s ecure it.See Figure
29.
6. Remove the belt a sfollows. Refer toFigure 30.
A. Loosen and remove the shoulder screw w hich a cts a sabelt
keeper.
B. Unhook the auger brake b racket spring from the frame.
7. Remove the belt f rom around the auger pulley, and slip the belt
between thesupport bracket and the auger pulley. See Figure 31.
8. Reassemble auger belt b yfollowing these i nstructions inopposite
order and manner ofremoval.
9. Perform t he Auger Control test o utlined inthe Assembly section
ofthis manual.
/
NOTE:Do NOTforgetto reinstallthe shoulderscrewand reconnect
the springto the frame after installinga replacementaugerbelt.
Figure29
f
Figure30
f
23
Figure31