Tuning In To A Station; Presetting Stations; Tuning In To A Preset Station - JVC LVT1370-001A Instructions Manual

Tuning in to a Station

1
Press BAND/TUNER.
The unit automatically tunes in to the
previously tuned station (either FM or AM).
• Each time you press the button, the band
alternates between FM and AM.
2
Press and hold 4 or ¢
for more than 1 second.
The unit starts searching for stations
and stops when a station of sufficient
signal strength is tuned in to.
• When the band is FM and a program is broadcast in
stereo, you can hear stereo sounds. (The STEREO
indicator appears).
To stop during searching, press 4 or ¢.
When you press 4 or ¢ briefly and repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is hard to
receive or noisy, press FM MODE/BEAT
CUT. "MONO" appears and the MONO
indicator lights up on the display. Reception improves.
To restore the stereo effect, press FM MODE/BEAT CUT
again.
"STEREO" appears and the MONO indicator goes off.
• The stereo effect is also restored when you tune in to
another station.

Presetting Stations

You can preset 20 FM and 20 AM stations.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 2
again.
1
Tune in to the station you want to preset.
• See "Tuning in to a Station" above.
2
Press PROGRAM/SET.
3
Press GROUP/PRESET UP
or GROUP/PRESET DOWN
to select a preset number.
BAND/
TUNER
4
Press PROGRAM/SET again.
The tuned station in step 1 is stored in the
preset number selected in step 3 .
• Storing a new station on a used number erases the
previously stored one.
When you unplug the AC power cord or if a power
failure occurs
The preset stations will be erased in a few days. If this happens,
preset the stations again. Even if the batteries are inserted in the unit,
this will occur unless the AC power plug has been disconnected
from the unit.
If the time limit comes while presetting the station
The tuned frequency will be stored. (When the preset number is not
selected, the tuned frequency will not stored.)

Tuning in to a Preset Station

1
Press BAND/TUNER.
The unit automatically tunes in the previously
tuned station (either FM or AM).
• Each time you press the button, the band
alternates between FM and AM.
2
Press GROUP/PRESET UP or
GROUP/PRESET DOWN to
select a preset number.
You can also select a preset number
by using number buttons on the
remote control.
For preset number 5, press 5.
For preset number 15, press OVER,
then 1, 5.
For preset number 20, press OVER,
then 2, 0.
– 13 –
BAND/
TUNER
OVER