Table of Contents
Advertisement
1. Remove the SIM cover (retain)
2. Make sure the ON/OFF switch is in the OFF position
3. Remove installation cover from bottom left hand corner of IDU (retain cover & screw)
4. Remove ground bolt, connect ground cable and replace the bolt to secure the ground connection (15 in-lbs
recommended torque). See Figure 14, reference 4.
5. Connect the other end of the ground wire to a local ground connection (not an electrical system ground)
using appropriate clamp or connection.
6. Fit power feed from the DC buss or from the supplied PSU to power connector on IDU, use strain relief
provided within IDU. See Figure 14, reference 6.
7. Connect RJ-45 connector from ODU/IDU cable to the IDU (See Figure 14, reference 7) and use strain relief
provided within IDU
8. After checking that all the connections are securely made and have strain relief, replace and fasten the
installation cover.
Figure 15.
Figure 16.
Data
Voice
connection
connections
Data
Voice
connection
connections
Insert SIM card
Insert SIM card
Slide locking tab
Provisioned lines will
Slide locking tab
illuminate green
Reset button
Provisioned lines will
illuminate green
Reset button
SIM
SIM
Iridium Pilot Land Station Installation Guide
21
Advertisement
Table of Contents
