Multi Zone; Zone2 Out - Yamaha RX-A810 Owner's Manual

■
Network Standby
Selects whether to turn on this unit by the command from other network devices
(network standby).
Settings
Off (default) Disables the network standby function.
Enables the network standby function.
On
(This unit consumes approximately 5 W of power.)
■
MAC Address Filter
Sets the MAC address filter to limit access to this unit from other network devices.
❑ Mode
Enables/disables the MAC address filter.
Settings
Off (default) Disables the MAC address filter.
Enables the MAC address filter. In "Address Setup", specify the MAC
On addresses of the network devices that will be permitted access to this
unit.
❑ Address Setup
Specifies the MAC addresses (up to 10) of the network devices that will be permitted
access to this unit when "Mode" is set to "On".

Multi Zone

Configures the multi zone settings.
■
Zone2 Set
Configures the audio output settings for Zone2.
• The "Zone2 Set" settings are available only when "Power Amp Assign" (p.91) is set to "7ch+1ZONE"
❑ Max Volume
Sets the Zone2 maximum volume so that sound is not too loud.
Setting range
-30.0dB ~ +15.0dB (5.0dB steps), +16.5dB
Default
+16.5dB
❑ Initial Volume
Sets the Zone2 initial volume for when this unit is turned on.
Settings
Off (default) Sets at the level when this unit last entered standby mode.
Sets at Mute, or -80.0dB ~ +16.5dB (0.5dB steps).
On
(This setting works only when "Max Volume" is set higher.)
98
En