Remote Control - Yamaha RX-A810 Owner's Manual

Problem
The files in the PC cannot be viewed or
played back.
The Internet radio cannot be played.

Remote control

Problem
This unit cannot be controlled using the
remote control.
External devices cannot be controlled
using the remote control.
The remote control does not learn new
functions.
Cause
The files are not supported by this unit or the media server.
The selected Internet radio station is currently not available.
The selected Internet radio station broadcasts audio silence
currently.
Access to the network is restricted by the firewall settings of your
network devices (router, etc).
Cause
Out of the operating range.
The batteries are weak.
Direct sunlight or lighting is striking the remote control sensor of
this unit.
The remote control is set to control external devices.
The remote control IDs of the main unit and remote control are not
identical.
The remote control is set to control this unit.
The corresponding remote control code is not set properly.
The batteries of the remote control of this unit and/or the external
device are weak.
The distance between the two remote controls is not appropriate.
The signal coding or modulation of the other remote control is not
compatible with this remote control.
Memory capacity is full.
Remedy
Use the file format supported by both this unit and the media server. For
information about the file formats supported by this unit, see "Playing back music
stored on PCs" (p.64).
It may not be available to listen because there might be a network problem, or the
station might be broadcasting in limited hour. Try the station later or select another
station.
Some Internet radio stations broadcast audio silence during particular periods of
time in a day. Try the station later or select another station.
Check the firewall settings of your network devices. The Internet radio can be
played only when it passes through the port designated by each radio station.
The port number is variable depending on radio station.
Remedy
Use the remote control in the operating range (p.5).
Replace with new batteries.
Adjust the lighting angle, or reposition this unit.
Press SOURCE/RECEIVER to set the remote control to control this unit (the key
lights up in orange).
Change the remote control ID of the main unit or remote control (p.104).
Press SOURCE/RECEIVER to set the remote control to control external devices
(the key lights up in green).
Set the remote control code again (p.106). Even if the remote control code is
registered properly set, some products may not respond to the remote control.
Replace with new batteries.
Place the remote controls at a proper distance (p.108).
Learning is impossible in this case.
Clear unnecessary assignments to free some memory space for the new
functions (p.109).
116
En