Power Management Setup - Gigabyte GA-M61PME-S2 User Manual

2-6
ACPI Suspend Type
Soft-Off by Power button
PME Event Wake Up
Modem Ring On
USB Resume from Suspend
Power-On by Alarm
x Day of Month Alarm
x Time (hh:mm:ss) Alarm
HPET Support
HPET Mode
Power On By Mouse
Power On By Keyboard
x KB Power ON Password
AC Back Function
ACPI Suspend Type
Specifies the ACPI sleep state when the system enters suspend.
Soft-Off by Power button
Configures the way to turn off the computer in MS-DOS mode using the power button.
PME Event Wake Up
Allows the system to be awakened from an ACPI sleep state by a wake-up signal from a PCI or
PCIe device. Note: To use this function, you need an ATX power supply providing at least 1A on
the 5VSB lead. (Default: Enabled)
Modem Ring On
Allows the system to be awakened from an ACPI sleep state by a wake-up signal from a modem
that supports wake-up function. (Default: Enabled)
(Note) Supported on Windows
GA-M61PME-S2 Motherboard
Downloaded from www.Manualslib.com

Power Management Setup

CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
(Note)
(Note)
: Move Enter: Select
F5: Previous Values
S1(POS) Enables the system to enter the ACPI S1 (Power on Suspend) sleep state
(default). In S1 sleep state, the system appears suspended and stays in a
low power mode. The system can be resumed at any time.
S3(STR) Enables the system to enter the ACPI S3 (Suspend to RAM) sleep state. In
S3 sleep state, the system appears to be off and consumes less power than
in the S1 state. When signaled by a wake-up device or event, the system
resumes to its working state exactly where it was left off.
Instant-Off Press the power button and then the system will be turned off instantly.
(Default)
Delay 4 Sec. Press and hold the power button for 4 seconds to turn off the system. If the
power button is pressed for less than 4 seconds, the system will enter
suspend mode.
Vista
®
manuals search engine
Power Management Setup
[S1(POS)]
[Instant-Off]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
Everyday
0 : 0 : 0
[Enabled]
[32-bit mode]
[Disabled]
[Disabled]
Enter
[Soft-Off]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
operating system only.
®
- 40 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults