IBM T00 Service Manual page 38

2. If more than one ac power distribution bus is installed in the rack, plug the power cable of each into
the customer's ac power outlet.
CAUTION:
This product is equipped with a three-wire power cable and plug for the user's safety. Use this
power cable with a properly grounded electrical outlet to avoid electrical shock.
C01
For illustration purposes, the type 6 power distribution bus is shown. However, this procedure also
applies to the type 7 and 9188/7188 power distribution buses.
L1
L1
1 Rear View of the Rack
2 Power Distribution Bus
3 View of the Power Distribution Bus
(Facing the Rack)
4 Outlets for Peripherals (Two Facing
the Front of the Rack)
3. Follow the power-on procedures for the drawers installed in the rack. For more information, refer to the
service guide for the drawers installed in the rack.
4. Close the rear door of the rack.
26
7014 Model T00, and Model T42 Service Guide
1
2
R6
CB6
R5
L1
CB5
R4
CB4
R3
CB3
R2
CB2
R1
CB1
L1
3
4
R7
CB7
5
R8
CB8
6
7
8
5 Reset Buttons (Two Facing the Front
of the Rack)
6 Reset Buttons
7 Outlet for Drawers
8 Power Cord (Plug Configuration May
Vary)