Table of Contents
Advertisement
8150 Technical Guide
STEP 5:
STEP 6:
9100-0212-04 - May 2000
Invert the Control Panel so that it faces up. You may now
reconnect it to the 8150 Signal Chassis. Make sure the
following cables are reconnected:
The Chassis communications cable
The DC power cable
The PC keyboard cable (if installed)
The mouse cable (if installed)
The external floppy disk drive cable (if installed)
When you power up the Control Panel, it takes about eight
seconds to boot up. If it is connected to an operating Signal
Chassis, the menu that was current when the Control Panel
was disconnected should appear in the LCD menu display.
The Hangman game appears to indicate that the Control
Panel is running but not communicating with the Signal
Chassis. Verify that the Signal Chassis is powered up and the
control cable is connected at both ends.
If the menu does not appear at all, check to make sure that
the LCD brightness and contrast controls (thumbwheels on
the left edge of the Control Panel) are set correctly for proper
viewing, as you may have disturbed these settings during
assembly/disassembly.
Assembly Removal /Replacement
Engineering Setup
5-73
Advertisement
Table of Contents
