Table of Contents
Advertisement
8150 Technical Guide
STEP 4:
STEP 5:
STEP 6:
STEP 7:
STEP 8:
STEP 9:
9100-0212-04 - May 2000
Press the Events softkey. Turn the Select GPO pushknob to
select GPI 1.
Press the Toggle GPO softkey. Note that the GPO Select
display changes from None to 1– – – – – – –. This indicates
that GPI Output 1 is selected.
Turn the Select GPO pushknob to select the GPI 4 output,
and press Toggle GPO again. Note that GPO Select now
displays 1 – – 4 – – – –, indicating that GPI outputs 1 and 4 are
selected.
Press the Quick Keyframes MODIFY button to modify
Keyframe 2 (which you selected in step 2) to trigger GPI
outputs 1 and 4.
Run the effect by pressing the RUN button. The GPO Select
display reads None until it reaches Keyframe 2, when it
changes to 1 – – 4 – – – . When it reaches Keyframe 3, it reverts
to None again for the rest of the effect. Any external device
whose GPI input is connected to GPI outputs 1 or 4 is
triggered at Keyframe 2 of this effect.
Repeat steps 6 and 7 to add more GPI outputs or trigger GPIs
on other keyframes. Numbers in the GPO Select display
indicate that those GPI outputs are active if saved as part of
a keyframe. To remove GPI outputs from a keyframe, select
the GPI output number with Select GPO and press Toggle
GPO to remove the number from the GPO Select display.
Press the Quick Keyframes MODIFY button to disable that
GPO for that keyframe.
Personality Menu
Engineering Setup
5-41
Advertisement
Table of Contents
