Danby DDW398W Service Manual page 19

PROCEDURE
Inspecting and replacing: Water inlet valve (continued)
Step 7: Disconnect incomming water
Water supply hose. Remove clamp
and detach smaller hose running into
dishwasher tub.
NOTE: If water continues to fill, even when power is disconnected, this is caused by damage to, or sediments
in valve housing or bellows. In either case entire valve should be replaced.
NOTE: If open winding in solenoid were proceeded by continuous filling and draining. Make sure timer is
Advancing through the fill cycle. Continuous duty will burn out water valve solenoid.
Step 8: Remove mounting screw that
secures fill valve to rear panel. Install
new valve and reconnect leads and
water lines. Reassemble dishwasher
and reconnect water and power supply.
17