7.
Remove the driver's sunvisor:
•
Pivot the right sunvisor downward.
•
Wrap tape around the tip of a flat-tip screwdriver.
•
Locate the slot in the bracket cover, and insert
the flat-tip screwdriver into the slot. Push in and
hold the retaining tab.
•
While holding the retaining tab, push up on the
sunvisor and rotate it toward the door.
NOTE: If the retaining tab did not stay pushed in,
return the sunvisor to its original position and repeat
this step.
BRACKET COVER
FLAT-TIP
SCREWDRIVER
TAPE
DRIVER'S
SUNVISOR
Push the
retaining tab.
4 of 25
RETAINING
TAB
FRONT
Make sure the
retaining tab
slides into the
bracket cover.
While pushing in
on the retaining
QB22902AK
tab, rotate the
sunvisor toward
the door.
•
Remove the driver's sunvisor (unplug the
vehicle connector).
VEHICLE
CONNECTOR
8.
Remove the driver's A-pillar trim.
•
Pull away the driver's door opening seal from the
driver's A-pillar trim.
•
Pull out on the driver's A-pillar trim to release
three clips.
DRIVER'S DOOR
OPENING SEAL
(Pull away.)
BII 48865 (1303)
DRIVER'S
SUNVISOR
Pull the clip.
DRIVER'S A-PILLAR
© 2013 American Honda Motor Co., Inc. – All Rights Reserved.
QB22903AK
2 CLIPS
DRIVER'S
A-PILLAR
TRIM
QB22904AK