TROUBLESHOOTING
TROUBLESHOOTING
The status light won't
• Make sure the AC adaptor is plugged into each base and wall outlet.
Make sure the handset is properly seated in the base.
illuminatewhenthe handset
•
Make sure the charging contacts on each handset and base are clean.
is placed on the base.
•
Move the handset and/or base to a different location away from
The audio sounds weak
•
metal objects or appliances and try again.
and/ or scratchy .
•
Press
•
Make sure that you are not too far away from the base.
Can't makeor receive calls.
• Check both ends of the telephone line cord are plugged in firmly.
• Make surethe AC adaptor is plugged into the baseand wall outlet.
• Disconnect the AC adaptor for a few minutes, then reconnect it.
• Make sure that you are not too far fromthe base.
• Charge the handset.
The handset doesn't ring or
• The battery pack may be weak.Charge the battery for 20-25hours.
receive a page.
• The handset may be too far away fromthe baseunit.
• Place the baseunit away from appliances or metal objects.
Handset number 1 or
• Place one handset at a time on the main base for 5 seconds each.
number 2 not working.
The Caller ID does not display.
• The handset was picked up before the second ring.
• The call was placed through a switchboard.
• Call your local telephone company to verify your Caller ID
service is current.
If you still have a problem.
Australia: www.uniden.com.au
Page 18
/channel while on a call to change the operating channel.
New Zealand: www.uniden.co.nz