Front Panel - Sony BVP-E10 Series Operation Manual

Front Panel

VF
AUTO W/B BAL
WHT
SHUTTER
OFF
ON
BLK
VTR START
SEL
MIC
LEVEL
gSHUTTER switch
hVTR START button
iLENS connector
jMIC connector
a VF (viewfinder) connector (20-pin)
Connect the 20-pin viewfinder cable of the BVF-10/10CE/
20W/20WCE viewfinder.
b Cable clamp
Secures a microphone cable and lens cable.
c Lens mount lever
Secures the lens to the lens mount.
For details, see "Attaching a Lens to the Camera".
d AUTO W/B BAL (automatic white balance/black
balance adjustment) switch
Adjusts the white balance and black balance
automatically.
WHT: The white balance is automatically adjusted.
When the WHITE BAL switch on the side of the
camera is set to A or B, the adjusted value is stored in
memory cell A or B.
BLK: The black balance is automatically adjusted. The
black set is simultaneously adjusted.
Note
The SHUTTER and AUTO W/B BAL switches do not
function when the camera is connected to a CCU, RCP, or
RM.
aVF connector
bCable clamp
cLens mount lever
dAUTO W/B BAL switch
eMENU SELECT knob
fMIC LEVEL control
e MENU SELECT knob
When the DISPLAY switch on the side panel is set to
MENU and the menu is displayed, turn this control to
select a menu item and press it to register the selection.
For details, see "Menu Operation".
f MIC LEVEL (microphone level) control
When a portable VTR is connected using the CCZ cable of
the CA-570/570P Camera Adaptor, the microphone level
can be adjusted by turning this control.
When the CA-570/570P Camera Adaptor is used and the
LEVEL/MIC switch on the rear panel of the camera
adaptor is set to FRONT/OFF, the sound volume of the
intercom can be adjusted using this control.
g SHUTTER switch
OFF: An electronic shutter does not function.
ON: An electronic shutter is activated.
SEL: The shutter speed and shutter mode change each
time the switch is set to this position.
h VTR START button
When a Camera Control Unit (CCU) is connected, the
audio signal of the intercom is sent to the CCU while this
button is held pressed.
When a VTR is connected using the CCZ cable of the
CA-570/570P, pressing this button starts recording, and
pressing it again stops recording. It is the same function as
with the VTR button on the lens.
i LENS connector (12-pin)
Connect a lens cable.
j MIC (microphone) connector (3-pin)
Connect a microphone cable.
Normally, connect the microphone supplied with the BVF-
10/10CE/20W/20WCE Viewfinder.
Phantom powering is turned off with the appropriate
internal switch setting.
For setting the switch, consult your Sony service
personnel.
Location and Function of Parts
11