Changing The Scanning Mode; Changing The Picture Tone - JVC DX-T9 Instructions Manual

Changing the Scanning Mode

• If you connect a progressive TV through the
COMPONENT jacks, you can enjoy a high quality picture
from the built-in DVD player by selecting progressive
scanning mode.
• You can change the setting only while the disc playback is
stopped.
1
Enter the scanning mode setting mode.
4
sec.
SCAN MODE
VFP
2
Select the scanning mode.
NTSC PROGRESSIVE
NTSC Interlaced scanning.
For a conventional TV.
NTSC Progressive scanning.
PROGRESSIVE
For a progressive TV.
3
Store the setting.
SET

Changing the Picture Tone

While viewing a playback picture on the TV, you can select
the preset picture tone, or adjust it and store your own
preference.
To select a preset picture tone
1
While playing, display VFP setting screen.
SCAN MODE
VFP
Remote
INFO
ONLY
NTSC
Remote
ONLY
NORMAL
GAMMA 0
0
BRIGHTNESS
0
CONTRAST
SATURATION 0
TINT 0
SHARPNESS 0
On the TV screen
2
Select a preset picture tone.
NORMAL Normally select this.
CINEMA Suitable for a movie source.
USER1/USER2
You can adjust parameters and can
store the settings (see below).
To adjust the picture tone
1
Select "USER1" or "USER2."
• Follow steps 1 and 2 above.
2
Select a parameter you want to adjust.
GAMMA Adjust if the neutral color is bright
or dark. The brightness of dark and
bright portions is maintained
(–3 to +3).
BRIGHTNESS Adjust if the picture is bright or dark
as a whole (–8 to +8).
CONTRAST Adjust if the far and near position is
unnatural (–7 to +7).
SATURATION Adjust if the picture is whitish or
blackish (–7 to +7).
TINT Adjust if human skin color is
unnatural (–7 to +7).
SHARPNESS Adjust if the picture is indistinct
(–8 to +8).
3
Adjust the parameter.
4
Repeat steps 2 to 3 to adjust other parameters.
To erase the VFP screen, press VFP again.
NORMAL CINEMA
USER2 USER1
ENTER
ENTER
15