Denon S-302 Owner's Manual page 53

~
Cause
Countanneasunt
Page
Internet radio • Ethernet cable is not properly • Check the connection status.
15
cannot be played. connected or network is
disconnected.
• Prograrn is being broadcast in • Only Internet radio programs in -
non-compatible format. MP3 and WMA can be played on
this set.
• The
computer's or router's • Check the computer's or router's
-
firewall is activated. firewall settings.
• Radio station is not currently • Choose a radio station that is 35
broadcasting. currently broadcasting.
• IP address is wrong. • Check the set's IP address. 20, 21
Server is not
• The
computer's or router's • Check the computer's or router's
-
found, or it is firewall is activated. firewall settings.
not possible to • Computer's power is not turned • Turn on the power. -
connect to the on.
server. • Server is not running.
• Launch the server.
-
• Set's IP address is wrong.
• Check the set's IP address.
20, 21
Cannot connect to • Radio station is not currently • Wait a while before trying again -
preset or favorite
broadcasting.
radio stations. • Radio station is not currently in • It is not possible to connect to -
service. radio stations that are no longer
in service.
For some • Station is congested or not • Wait a while before trying again.
-
radio stations, currently broadcasting.
"Server Full"
or "Connection
Down" is
displayed and
station cannot be
connected to.
Sound is broken
• Network's signal transfer speed • This is not a malfunction. When
-
during playback. is slow or communications lines playing broadcast data with a
or radio station is congested. high bit rate, the sound may
be broken, depending on the
communications conditions.
Sound quality is
• File being played has a low bit • This is not a malfunction. -
poor or played rate.
sound is noisy.
[Wireless LAN]
Symptom
Cause Cou~ .~~
Cannot connect ·The settings of the SSID • Match the network settings with 21
to network. and network key (WEP) are the S-302's settings.
incorrect.
• The reception is poor and the • Shorten the distance from the -
signals cannot be received. wireless LAN's access point,
remove any obstacles
and
otherwise improve visibility, then
try reconnecting. Also install
away from microwave ovens
and the access points of other
networks.
• There are multiple networks and • Set the access point's channel
-
the usable channels overlap. settings away from the channels
used for other networks.
Alternatively, connect using a
network cable.
Played sound is • There are multiple networks and • Set the access point's channel
-
interrupted or the usable channels overlap.
settings away from the channels
sound cannot be used for other networks.
played.
Alternatively, connect using a
network cable.
49