Maclaren quest User Manual page 12

Instructions
IMPORTANT:
READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP THEM FOR FUTURE REFERENCE.
YOUR CHILDREN'S SAFETY MAY BE AFFECTED IF YOU DO NOT FOLLOW THESE INSTRUCTIONS.
1 TO OPEN THE BUGGY
A Release storage clip.
B Open out the buggy.
C Using foot, push the brake pedal down fully to engage
the primary locks.
CAUTION: Ensure that all locking devices are engaged
before use.
2 TO OPERATE BRAKES
Locate the brake lever at the back of the buggy frame.
A TO ENGAGE BRAKES: With foot, press down on the left
side of the pedal.
B TO RELEASE BRAKES: With foot, press down on the right
side of the pedal.
CAUTION: Parking device shall be engaged during the
loading and unloading of children.
CAUTION: Ensure parking device is engaged before leaving
the buggy unattended.
3 TO OPERATE FRONT WHEEL SWIVEL LOCKS
A TO LOCK SWIVELS: Align front wheels and press down
on locking levers.
B TO UNLOCK SWIVELS: Raise locking levers.
4 SEAT BELT/SHOULDER HARNESS OPERATION
WARNING:
AVOID SERIOUS INJURY FROM
FALLING OR SLIDING OUT.
ALWAYS USE SEAT BELT
TO FIT HARNESS:
A Pull shoulder straps over the childs shoulder then attach
to the waist clips by sliding strap loops onto the hooks.
B I nsert both waist clips into the clasp, shoulder straps
are secured once the clips are fastened.
C A djust strap lengths by sliding buckles. Belt and
harness should be snug.
TO RELEASE HARNESS:
D P ress the button on both the front and back of the
clasp simultaneously to release.
5 TO ADJUST SEAT RECLINE
A TO RECLINE SEAT BACK: Lift both hand grips to release
seat locks and slide the seat back to desired position.
Lower hand grips to engage locks on both sides.
B TO RAISE SEAT BACK: From rear of buggy push seat
back to original upright or desired intermediate
position.
6 TO OPERATE THE LEGREST
TO EXTEND THE LEGREST: Feel through seat corner
openings. Locate sliders and pull forward. Reverse this
process to retract legrest.
7 TO FIT THE SHOPPING BAG
CAUTION: Overloading may cause a hazardous unstable
condition to exist. Maximum load 4.4 lb (2 kg) evenly
distributed.
The buggy may be folded with the bag still attached but all
contents must be removed. Failure to do this could
damage buggy and contents of shopping bag.
A Place bag on the 'X' frame under seat with lowest edge
of bag at front.
B Attach front straps to front legs just below seat.
C Attach rear straps to rear legs just above horizontal tie bar.
8 TO ATTACH THE HOOD
CAUTION: Overloading may cause a hazardous unstable
condition to exist. Maximum carrying capacity of hood
pouch - 1.1lb (0.5kg.)
A Slide left hand and right hand pivot blocks DOWN over
the retainers located on the handle tubes.
B Place rear apron behind seat back.
C Extend hood and press down on side hinges to
lock open.
9 TO FIT THE RAIN APRON
A Place the apron over the hood front.
B Attach two eyelets (one each side) to the hood clips.
C Attach the two eyelets (one each side) to the front legs.
10 REMOVING AND REFITTING THE SEAT COVER
Remove hood from buggy if fitted.
A Twist shoulder strap end buckles and feed through holes.
B Feed waist and crotch straps through holes.
C Unclip seat cover retaining straps.
D Unfasten seat fabric from handle tubes and seat base.
E Slide fabric from seat back and base.
F When refitting seat fabric, insert seat back support
tubes into fabric slits.
G When refitting seat fabric to seat base, loop fabric flap
over legrest strap and pass crotch strap buckle through
both holes in seat fabric and then hole in seat base.
H When refitting shoulder straps, choose the fabric holes
appropriate to the child's size. Twist the buckles and
feed through seat fabric and then through holes in seat
back arms.
11 TO REMOVE THE CARRY STRAP
A Release the primary lock and secondary lock.
B Press clip release and remove clip from 'D' ring.
C Slide strap loops from handles.
D Using foot, push the brake pedal down fully to engage
the primary lock.
12 TO FOLD THE BUGGY
Ensure the seat back is in its fullest upright position and the
hood(if fitted) is folded back. Remove contents of shopping
bag. It is recommended that the harness is fastened before
folding the buggy.
A Using foot, lift up on brake pedal to release primar lock.
B Push down on secondary lock lever.
C Grip handles and push forward on buggy.
D Compress folded buggy and engage storage clip.
en
3