Connecting Speakers - JVC CA-UXZ7MD Instructions Manual

AM antenna
1
2
3
AM loop antenna
(supplied)
1
If cords are covered with insulation, twist the core of
the cord at the end of each cord, then remove the
insulation.
2
Connect the AM loop antenna to the AM LOOP
terminals as illustrated.
3
Turn the AM loop antenna until you have the best
reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered
wire to the AM EXT terminal and extend it horizontally.
The AM loop antenna must remain connected.
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.

Connecting Speakers

To connect speakers
You can connect the speakers using the speaker cords.
Vinyl-covered wire
(not supplied)
1
2
3
4
– 7 –
1
2
Speaker terminals
SPEAKERS
Red
R
R
CAUTION:
SPEAKER IMPEDANCE 4~16
Black
Speaker cord
Rear of the right
speaker
If cords are covered with insulation, twist the core of
the cord at the end of each cord, then remove the
insulation.
Hold the clamp of the speaker terminal.
Insert the end of the speaker cord to the terminal.
Match the polarity of the speaker terminals: Red (+) to
red (+) and black (–) to black (–).
Release the finger from the clamp.
IMPORTANT
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
• DO NOT connect more than one speaker to one speaker
terminal.
3,4
Black
Red
L
L
Ω
Black
Rear of the left
speaker