Before Starting The Engine; How To Start The Engine - Toyota Land Cruiser 2003 Owner's Manual

Land cruiser 2003
Hide thumbs Also See for Land Cruiser 2003:
Table of Contents

Advertisement

WWW.MANUALS.WS

Before starting the engine

1. Check the area around the vehicle be-
fore entering it.
2. Adjust seat position, seatback angle,
head
restraint
height
and
steering
wheel angle.
3. Adjust the inside and outside rear view
mirrors.
4. Lock all doors.
5. Fasten seat belts.
210
WWW.MANUALS.WS

How to start the engine–

(a) Cranking hold function
Once you turn the ignition key to "START"
position and release it, the cranking hold
function continues to crank the engine in
"ON" position until it starts.
The function stops cranking the engine
after about 25 seconds maximum if the
engine has not started yet. When you
crank the engine again, wait a few sec-
onds and restart it.
If you hold the key in "START" position,
the function will keep cranking for about
30 seconds maximum.
(b) Before cranking
1. Apply the parking brake firmly.
2. Turn off unnecessary lights and acces-
sories.
3. Put the selector lever in "P". If you
need to restart the engine while the
vehicle is moving, put the selector le-
ver in "N". A starter safety device will
prevent the starter from operating if the
selector lever is in any drive position.
4. Depress the brake pedal and hold it
to the floor until driving off.
'03 L/C U (L/O 0301)
(c) Starting the engine
Before starting the engine, be sure to fol-
low the instructions in "(b) Before crank-
ing".
Normal starting procedure
The multiport fuel injection system/sequen-
tial multiport fuel injection system in your
engine automatically controls the proper
air–fuel mixture for starting. You can start
a cold or hot engine as follows:
1. With your foot off the accelerator ped-
al, turning the ignition key to "START"
position, then release it.
2. After the engine runs for about 10 se-
conds, you are ready to drive.
If the weather is below freezing, let the
engine warm up for a few minutes be-
fore driving.
If the engine stalls...
Simply restart it, using the correct proce-
dure given in normal starting.
If the engine will not start...
See "If your vehicle will not start" on page
226.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents