JVC CA-UXA7DVD Instructions Manual page 19

To select the output signal type—Step 3:
If you connect audio equipment to the DVD OPTICAL
DIGITAL OUT terminal, you need to select the type of
digital signals output through the terminal according to the
particular kind of audio equipment.
1
Press Cursor 5 to move
MONITOR TYPE
SCREEN SAVER
ON SCREEN GUIDE
PRESS KEY
2
Press Cursor 2 to move
The AUDIO menu appears on the TV.
DIGITAL AUDIO OUTPUT
DOWN MIX
COMPRESSION
PRESS KEY
3
Press Cursor ∞ to move
OUTPUT."
DIGITAL AUDIO OUTPUT
DOWN MIX
COMPRESSION
PRESS KEY
4
Press Cursor 3/2 to select the output signal type.
Select the output signal type according to the
guidelines on the right column.
To exit from the setting menu, press CHOICE while
holding down SHIFT.
The setting menu goes off.
• You can also exit from the setting menu by pressing
Cursor 5/∞ to select EXIT in the menu, then press
ENTER.
to "DISPLAY."
4:3 LB
MODE 2
ON
EXIT
to "AUDIO."
STREAM/PCM
Lo / Ro
ON
EXIT
to "DIGITAL AUDIO
STREAM/PCM
Lo / Ro
ON
EXIT
7 Guidelines to select the output signal type
Selectable types: STREAM/PCM, PCM ONLY,
DOLBY DIGITAL/PCM
• STREAM/PCM:
Select when connecting an amplifier or a decoder
compatible with DTS, Dolby Digital and MPEG
Multichannel.
• PCM ONLY:
Select when connecting an amplifier compatible only
with Linear PCM or a digital recording device such an
MD recorder, DAT deck, etc.
• DOLBY DIGITAL/PCM:
Select when connecting an amplifier or a decoder
compatible only with Dolby Digital.
Output Signals Through the DVD OPTICAL DIGITAL
OUT Terminal
Playback
disc STREAM/PCM
DVD with
48 kHz,
48 kHz,
16 bit
16 bit
Linear PCM
Linear PCM
DVD with
48 kHz,
48 kHz,
20/24 bit
20/24 bit
Linear PCM
Linear PCM
DVD with
96 kHz, No output
Linear PCM
DVD with Dolby Digital
Dolby Digital bitstream
DVD with DTS DTS bitstream
DVD with
MPEG
MPEG
bitstream
Multichannel
44.1 kHz,
SVCD/VCD/
16 bit
Audio CD
Linear PCM
Audio CD with
DTS Digital DTS bitstream
Surround
MP3 disc No output
When "PCM ONLY" or "DOLBY DIGITAL/PCM"
is selected as the output signal type
The sound signals of DTS are not output from the DVD OPTICAL
DIGITAL OUT terminal.
To listen to the sound of DTS on audio equipment connected to the
terminal, select "STREAM/PCM" as the output signal type.
When "PCM ONLY" is selected as the output signal
type
Also set "DOWN MIX" in the AUDIO menu. (See page 57.)
Output signals
DOLBY DIGITAL/
PCM ONLY
PCM
| |
| |
| |
48 kHz,
Dolby Digital
16 bit
bitstream
Linear PCM
No output |
48 kHz,
|
16 bit
Linear PCM
| |
| |
| |
16