Corded Buttonhole - Janome Memory Craft 10001 Instruction Manual

Janome MC10001 Instruction Manual
Sensor BH
Pull down BH Lever
17 18
SEN AUT
22
23
27 28
1
www.aaasewing.com
Auto
R
21
19 20
25
24
26
29 30
31
2

Corded buttonhole

To sew the corded buttonhole, follow the same
procedure as Sensor Buttonhole; refer to the
instructions on pages 58 to 60.
With Automatic Buttonhole Foot R raised, hook
the filler cord on the Spur at the back of the
buttonhole foot.
Bring the ends of cord toward you under the
buttonhole foot clearing the front end.
Hook the ends of the filler cord into the Forks
on the front of Automatic Buttonhole Foot R, to
hold them tight.
1 Spur
2 Forks
Lower the needle into the garment where the
buttonhole will start and lower the foot.
Press the Start/Stop Button and sew the but-
tonhole. Each side of the buttonhole and the
bartacks will be sewn over the cord.
The machine stops automatically when
finished.
Remove the fabric from the machine and cut
the sewing threads only.
Pull the left end of the filler cord to tighten it.
Thread the end of the cord through a darning
needle, draw it to the wrong side of the fabric
and cut.
NOTES:
• Set the stitch width in accordance with the
thickness of the cord used.
• To cut the buttonhole opening, refer to the
instructions on page 60.
62
MC10001 Owners Manual/ User Guide