Connecting The Power Supply - Janome Memory Craft 10001 Instruction Manual

Janome MC10001 Instruction Manual
6
www.aaasewing.com
1
3
2

Connecting the Power Supply

The Memory Craft 10001 is equipped with
an auto voltage system, which automatically
adjusts the equipment to any local power
supply voltage between 100 and 240V, 50/
60Hz.
Turn off the Power Switch, insert the Foot
Control Plug and Machine Plug into the
machine, then Power Supply Plug into the
5
wall outlet in this order.
Turn on the Power Switch.
1 Power Switch
2 Foot Control Plug
3 Machine Plug
4 Power Supply Plug
5 Power Supply Cord
6 Foot Control
4
NOTES:
• Make sure to use the Power Supply
Cord that came with the machine.
• If you turn off the power switch, wait 5
seconds before turning it on again.
• The Foot Control cannot be used in
Embroidery Mode.
For Your Safety:
• While in operation, always keep your eyes
on the sewing area, and do not touch any
moving parts such as the thread take-up
lever, handwheel or needle.
• Always turn off the Power Switch and
unplug from the power supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
• Do not place anything on the Foot
Control.
Operating Instructions:
• The symbol "O" of a switch indicates the
"off" position of a switch.
• For appliances with a polarized plug (one
blade wider than the other). To reduce the
risk of electric shock, this plug is intended
to fit in a polarized outlet only one way. If
it does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a
qualified electrician to install the proper
outlet. Do not modify the plug in any way.
7
MC10001 Owners Manual/ User Guide