Power Inverter - Jeep Compass 2010 User Manual

ELECTRONICS
Programming A Rolling Code System
• At the garage door opener motor (in the garage), locate the "learn" or "programming"
button. This can usually be found where the hanging antenna wire is attached to the
garage door opener motor (it is not the button normally used to open and close the door).
• Firmly press and release the "learn" or "programming" button then, within 30 seconds,
return to the vehicle and press the programmed HomeLink
button for two seconds each time). If the device is plugged in and activates, programming
is complete.
• If the device does not activate, press the button a third time (for two seconds) to complete
the programming.
Using HomeLink ®
• To operate, simply press and release the programmed HomeLink
programmed device will operate.
• Refer to your Owner's Manual on the DVD for further details. If you have any problems
programming HomeLink
on the Internet, at www.HomeLink.com.

POWER INVERTER

NOTE: The power inverter is designed with built-in overload protection. If the power
rating of 150 Watts is exceeded, the power inverter will automatically shut down. Once the
electrical device has been removed from the outlet, the inverter should automatically reset.
If the power rating exceeds approximately 170 Watts, the power inverter may have to be
reset manually. To reset the inverter manually, unplug the device and plug it in again. To
avoid overloading the circuit, check the power ratings on electrical devices prior to using
the inverter.
®
, or require assistance, please call toll-free 1–800–355–3515 or,
• A 115 Volt, 150 Watt AC power inverter is
located on the front of the center console.
• This outlet can power cellular phones,
electronics and other low power devices
requiring power up to 150 Watts.
34
®
button twice (holding the
®
button and the