Connecting Speakers - JVC CA-MXG70 Instructions Manual

AM antenna
ANTENNA
1
AM EXT
AM LOOP
FM 75
COAXIAL
2
AM loop antenna
(supplied)
1
Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
• If the AM loop antenna wire is covered
with vinyl, remove the vinyl by twisting
it as shown in the diagram.
2
Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. The AM
loop antenna must remain connected.
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.

Connecting Speakers

Vinyl-covered wire
(not supplied)
1
2
3
– 7 –
1
Red
Speaker cords
(red/black)
RIGHT
Black
RIGHT
CAUTION: SPEAKER
Blue
Speaker cords
(blue/black)
Right speaker
Open the speaker terminals on the rear of the
unit.
Insert the end of the speaker cord into the
terminal.
Match the polarity (colors) of the speaker terminals: Red
(+) to red (+) and black (–) to black (–); Blue (+) to blue
(+) and black (–) to black (–).
Close the speaker terminals.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
3
2
Speaker cords
SUBWOOFERS
(red/black)
LEFT
Black
LEFT
MAIN
SPEAKERS
IMPEDANCE
6 16
Left speaker