Protecting Images - Sony Cyber-shot DSC-P71 Service Manual

DSC-P71/P71M
To stop the playback of the slide
show
Press the center z, select "EXIT" using B,
then press the center z.
To fast forward or to go back to a
previous image during a slide
show
Press the B (Forward), or the b
(Backward).
• The interval settings are just guidelines. The
actual intervals will differ, based on factors like
the size of the image.
68

Protecting images

– Protect
Mode dial setting:
To prevent accidental erasure of an
important image, you can protect it.
Control button
MENU button
Mode dial
Rotating still images
Mode dial setting:
Images shot when holding the camera
vertically can be rotated and displayed
horizontally.
For single images
a Turn the mode dial to
b Display the image you want to
protect using b/B.
c Press the MENU button.
The menu appears.
d Select "PROTECT" using b/B,
then press the center z.
The image currently being displayed is
now protected, and a - (Protect)
mark is shown on the screen.
2048
5 5
/
DELETE PROTECT PRINT SLIDE
OK
To cancel the protection applied
to an image
In Step 4, press the center z again. The
- (Protect) mark disappears.
1-32
a Turn the mode dial to
display the image you want to
rotate.
b Press the MENU button.
The menu appears.
c Select "ROTATE" using b/B,
then press the center z.
d Select "
rotate the image using b/B.
e Select "OK" using b/B, then
press the center z.
To cancel rotation
In Step 4, select "CANCEL", then press
the center z.
• Protected images (page 69)/movies (MPEG
MOVIE)/Clip Motion/Multi Burst images
cannot be rotated.
• Images shot on other cameras may not rotate
correctly on this camera.
• When viewing images on a personal computer,
the image viewing software used may not
handle the rotation information correctly.
For Index (9 images) screen
a Turn the mode dial to
.
the W zoom button once, the
Index (9 image) screen
appears.
b Press the MENU button.
The menu appears
c Select "PROTECT" using b/B,
and press the center z.
d Select "SELECT" using b/B,
and press the center z.
The frame around the selected image
turns green.
e Select the image you want to
protect using the control
button, and press the center
z.
A - (Protect) mark will be attached
to the selected image.
•
SET
, and
" using v/V, and
Still image editting
, press
MENU TO NEXT
69