Sanyo PDG-DXT10L Service Manual page 73

8-2-2 Replacing the Lamp
When a lamp reaches the end of it's usable life, the following message is displayed. Replace the lamp.
The projection lamps should be replaced when they burn out. They should only be replaced with a certified
replacement part, contact your local dealer if unsure.
Note:
1. Lamps are positioned differently. Take care not to force the lamps when replacing.
2. Installation of both lamp modules (Lamp 1 and Lamp 2) is required to operate the projector in dual
or single lamp mode. If only a single lamp module is installed, the projector's lamp will not turn on and
will appear as a lamp failure
3. Lamps last approximately 2000-2100 hours (2500-2600 hours in Eco mode) and the End of lamp
life message is displayed during the lamps' final 100 hours of operational life. Please replace during
2000-2100 hour.
Important:
1. The lamp contains a certain amount of mercury and should be disposed of according to local
ordinance regulations.
2. Avoid touching the glass surface of the new lamp: doing so may shorten its operation life.
3. The lamp's useful life ends and projector could not turn on over 2100 hours. Please have the
projector serviced.
- 73-
PDG-DXT10L