Subscribe to Our Youtube Channel
Related Manuals for Federal Signal Corporation Echo E2
Summary of Contents for Federal Signal Corporation Echo E2
- Page 1 MODEL E2 INSTALLATION AND SERVICE INSTRUCTIONS FOR FEDERAL MODEL E2 INTERCOMS 2562334A REV. A1 0814 Printed in U.S.A.
- Page 2 blank page...
- Page 3 INSTALLATION AND SERVICE INSTRUCTIONS MODEL E2 INTERCOMS SAFETY MESSAGE TO INSTALLERS, USERS AND MAINTENANCE PERSONNEL It is important to follow all instructions shipped with this product. This device is to be installed by trained personnel who is thoroughly familiar with the country electric codes and will follow these guidelines as well as local codes.
- Page 4 INSTALLATION Unpacking After unpacking the unit, examine it for damage that may have occurred in transit. If the equipment has been damaged, do not attempt to install or operate it. File a claim immediately with the carrier stating the extent of the damage. Carefully check all envelopes, shipping labels, and tags before removing or destroying them.
- Page 5 MAINTENANCE SAFETY MESSAGE TO MAINTENANCE PERSONNEL Listed below are some important safety instructions and precautions you should follow: • Read and understand all instructions before operating this unit. • Any maintenance to the unit must be performed by properly trained personnel.
- Page 6 Part No. Description K122367 Keypad K137200-01 Headset K137154 Stubby Microphone K137154-01 Gooseneck Microphone, 150 mm K137154-02 Gooseneck Microphone, 330 mm K137154-03 Gooseneck Microphone, 480 mm K2005152 PCBA, Relay K2001908 PCBA, Microprocessor K8601293 Handset Assembly, Coiled Cord Keypad Replacement (Figure 2) Remove the enclosure cover by loosening the four captive 1/4”...
- Page 7 Remove the (3) 8-32 hex nuts that retain the microphone to the cover. Remove the microphone from the cover. Re-use the mounting hardware to attach the replacement microphone to the cover. Reverse the steps to re-assemble the unit. 10. Test the unit for proper operation after replacement is complete. Handset Replacement Remove the enclosure cover by loosening the four captive 1/4"...
- Page 8 LINE VOLTAGE WIRING (240 Vac, 20 A MAX.) DATA/POWER LINES FROM ECHO CENTRAL CONTROL (ISDN) RELAY OUTPUT (240 Vac / 30 Vdc, 3 A MAX.) AUX. POWER FOR SPEAKER (240 Vac, 20 A MAX.) AUDIO LINES TO CONNECTOR CARD T-300CK ON FS POWERED SPEAKER 290A5745B Figure 1.
Need help?
Do you have a question about the Echo E2 and is the answer not in the manual?
Questions and answers