Cleaning; Cleaning Stainless Steel/Avoiding Corrosion; Cleaning The Condenser - Perlick FR24 Series Installation And Operation Instructions Manual

Cleaning Instructions –

Cleaning the Condenser:

The condenser (located behind the front
■
grille) should be inspected every 30 days,
and cleaned, if necessary. Failure to keep
the condenser clean will cause a loss in
condensing unit efficiency, or compressor
failure.
Cleaning the doors:
■ Doors should be periodically removed from the
cabinet and inspected for a buildup of foreign
materials, such as syrups, beer, etc. Buildups
on the underside of the doors, along with the
cabinet breaker strips on which they ride, will
cause them to bind, and therefore, not function
as designed. If dirty, these surfaces should be
cleaned with a mild detergent and water then
coated with a silicone lubricating material.
Aerosol silicone sprays can be obtained locally
at most department or automotive stores.
Avoiding Stainless Steel Corrosion
Corrosion can be prevented by following product cautions, cleaning instructions and avoiding use of cer-
tain chemicals or objects which will cause stainless steel corrosion.
STAINLESS STEEL ENEMY
■ Steel wool or steel scouring pads
■ Cherry/orange/olive juice
■ Chlorine Bleach
■ Sharp objects
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.
Glass Frosters
To remove doors:
■ With door closed, lift it upward by its handle and
slide forward until door clears the cabinet top.
Use the reverse procedure to reinstall the doors.
Cleaning the Cabinet:
■ Use a damp cloth with a mild detergent and
water to clean the inside and outside of the
cabinet. Dry thoroughly. Do not allow cleaning
agents or large amounts of water to go down
the drain. Use an acceptable stainless steel
polish to clean all stainless steel surfaces.
Never use steel wool or scouring pads to clean
stainless steel.
5
Form No. Z2296
Rev. 12.05.09