Advertisement
Quick Links
INSTALLATION AND INSTRUCTION MANUAL
Star Phantom
Star Phantom
Undercover Interior Discrete LED Lightbar
ULB42V
Value Phantom
IMPORTANT:
Please read all of the following instructions before installing your new warning light.
The
The
Models
ULB42
Phantom
Starburst Phantom
®
ULB44
PLITSTR299 REV. J
5/20/14
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Phantom Star Phantom ULB42V
Summary of Contents for Phantom Star Phantom ULB42V
- Page 1 INSTALLATION AND INSTRUCTION MANUAL Star Phantom Star Phantom ® Undercover Interior Discrete LED Lightbar Models ULB42V ULB42 ULB44 Value Phantom Phantom Starburst Phantom IMPORTANT: Please read all of the following instructions before installing your new warning light. PLITSTR299 REV. J...
- Page 2 Mounting ® Star Phantom line of lights is designed to be mounted on the inside of your vehicle. They are not intended for exterior applications and are not warranted against water damage.
- Page 3 Mounting (CONT'D) These lights are designed to be mounted in the front windshield of a vehicle using the pre-existing visor clips. 1. Slide the enclosed rubber channel over the front edge of the baffle . 2. Insert a carriage bolt through one of the 1/4”...
- Page 4 Mounting (CONT'D) 5. Locate the two visor clips on the vehicle. The style may vary from vehicle to vehicle. Some styles use only one screw each, while others may have more. Verify that both visor clips are a minimum of 3” from the center of the window, and a maximum of 8”...
- Page 5 Mounting (CONT'D) 11. Loosen the five Baffle Adjusting Screws located on the bottom of the ® Starburst Phantom 12. Slide the baffle forward until it satisfactorily blocks any reflected light. 13 Tighten the Baffle Adjusting Screws to secure the baffle in place .
-
Page 6: Operating Instructions
Testing the light before this fuse is properly installed will void the warranty on the light. ® The Star Phantom is designed for simple operation using three switches. This unit has a 3-Way Mode Switch, a Map Light Button, and a Pattern Select/Burst Mode Button. - Page 7 Indicator LED: Pressing and holding the pattern select button until the LED’s flash four times • (approx. 12 seconds) will disable or enable the indicator LED. ® Starburst Phantom will remember the pattern it was in when turned off and • display the same pattern when re-activated.
- Page 8 These lights use state-of-the-art Light Emitting Diode (LED) technology. These warning lights are comprised of ultra-high intensity LEDs that are controlled by a solid state flasher unit to efficiently produce light output with lifetimes up to 100,000 hours. Under normal circumstances, you will not need to replace any LEDs in this light.
Need help?
Do you have a question about the Star Phantom ULB42V and is the answer not in the manual?
Questions and answers